http://qa.mandrakesoft.com/show_bug.cgi?id=3388
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
Status|UNCONFIRMED |RESOLVED
Resolution| |WORKSFORME
------- Additional Comments From [EMAIL PROTECTED] 2003-03-21 08:43 -------
Thanks to Bruno Prior who sent the trick on cooker.
Using ide=nodma on the command line fixed the boot.
The kernel documentation is misleading:
ide?= [HW] (E)IDE subsystem : config (iomem/irq), tuning or
debugging (serialize,reset,no{dma,tune,probe}) or
chipset specific parameters.
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: RESOLVED
creation_date:
description:
2.4.19-16mdk boots fine on this machine, but this new kernel won't, even with
acpi=off noapic. It fails to use the hard-drive:
CDM643: simplex device. DMA forced
hda: IBM-DCRA-22160, ATA DISK drive
...
partition check:
hda: lost interrupt
hda: dma_intr: bad DMA status (dma_stat=1)
hda: dma_intr: status=0x50 {DriveReady, SeekComplete}
and so on every time it tries to access the hard drive. I tried to boot with
ide0=nodma ide1=nodma, but it does not change anything.
# hdparm -I /dev/hda
/dev/hda:
ATA device, with non-removable media
Model Number: IBM-DCRA-22160
Serial Number: A30A31G3820
Firmware Revision: A81AD0
Standards:
Used: ATA-3 X3T10 2008D revision 1
Supported: 3 2 1
Configuration:
Logical max current
cylinders 4200 4200
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 4233600
LBA user addressable sectors: 4233600
device size with M = 1024*1024: 2067 MBytes
device size with M = 1000*1000: 2167 MBytes (2 GB)
Capabilities:
LBA, IORDY(can be disabled)
Buffer size: 96.0kB bytes avail on r/w long: 4
Standby timer values: spec'd by Vendor
R/W multiple sector transfer: Max = 16 Current = 16
DMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
Power Management feature set
Security Mode feature set
SMART feature set
Of course, that means that the install floppy does not boot either.
