http://qa.mandrakesoft.com/show_bug.cgi?id=3308
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
Status|UNCONFIRMED |RESOLVED
Resolution| |FIXED
------- Additional Comments From [EMAIL PROTECTED] 2003-03-29 10:02 -------
Installed 9.1 and the network config was autodetected. Nice work.
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: RESOLVED
creation_date:
description:
Don't know if this helps...
I've just brought a new US Robotics MOD-7900 NIC, and drakconnect doesn't auto
detect it. Reading about on the net, I discover that the tulip driver works with
this card. I've been testing this, and it does indeed work very nicely. Can you
add auto-detect for this card to drakconnect which selects the tulip driver. No
additional flags where required, just add 'alias eth0 tulip' in /etc/modules.conf.
> dmesg | grep eth0
eth0: ADMtek Comet rev 17 at 0xd800, 00:C0:49:B3:F6:FB, IRQ 10.
> lspci -vv
00:0d.0 Ethernet controller: Accton Technology Corporation EN-1216 Ethernet
Adapter (rev 11)
Subsystem: U.S. Robotics: Unknown device 00ed
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (63750ns min, 63750ns max), cache line size 08
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at d800 [size=256]
Region 1: Memory at cfffdc00 (32-bit, non-prefetchable) [size=1K]
Expansion ROM at cffc0000 [disabled] [size=128K]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=100mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+
