http://qa.mandrakesoft.com/show_bug.cgi?id=3690
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
Version|9.1-29mdk |9.2-0.7mdk
------- Additional Comments From [EMAIL PROTECTED] 2003-01-07 17:16 -------
This bug has been automatically updated to last version of product available.
Please check if it is still valid.
--
Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: UNCONFIRMED
creation_date:
description:
When trying to use either to autodetection (during install) or expert mode drakconnect
recognises my ethernet (3c905) and my wireless (prism2 .. orinoco) as one single card.
For some reason it configures an ethernet0 and an ethernet1 but when using drakconnect
to reconfigure it only shows the ethernet0 (ethernet card).
This causes problems when booting because it always waits and gives an error message
when starting the interfaces (although the do work).
The end result is that drakconnect can't be used to configure my wireless card (aka,
SSID's and WEP keys and mode).
Platform: Delle Latitude c840 (built in ethernet and built in dell latitude truemobile
wireless)
sometimes drakconnect does not even show any connected network cards ?
I can see from the newsgroups that i'm not the only one experiencing this problem !
