http://qa.mandrakesoft.com/show_bug.cgi?id=5166
------- Additional Comments From [EMAIL PROTECTED] 2003-09-09 01:37 ------- Well another thing worth noting is that I did run an upgrade from 9.1 to 9.2 RC1. Another weird occurence just happened a few minutes ago. After going through the describe fix the wireless stop working after a few hours. I noticed my signal strength go to 0. Then I tried a 'ifdown eth0' which worked. Then a 'ifup eth0' which resulted in the same error message about no cable. Is there some cron job that would have messed with that?? -- Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: ASSIGNED creation_date: description: When I run the network wizard my wireless ethernet works perfect. Then when I reboot I get the error message that there is no cable present. Then if i run the wizard again the internet works fine again until the next time that I reboot my computer. Here is the listing for my card from harddrake Vendor: ‎Harris Semiconductor Bus: ‎PCI Bus identification: ‎1260:3873:1468:200 Location on the bus: ‎0:9:0 Description: ‎Prism 2.5 Wavelan chipset Module: ‎orinoco_pci Media class: ‎NETWORK_OTHER
