On Tue, 2003-09-09 at 22:29, Jeff Shultz wrote:
> On Tue, 2003-09-09 at 19:09, Byron Poland wrote:
>
> > RC2 installed fine on my 120 gig Seagate SATA drive, on an Silicon Image
> > SATA controller, that is on my asus nforce2 mb
> >
> > from lspcidrake:
> >
> > Silicon Image|Sil3112A Serial ATA [STORAGE_RAID]
> >
> > hdparm -i /dev/hde
> >
> > /dev/hde:
> >
> > Model=ST3120026AS, FwRev=3.05, SerialNo=3JT0JJKQ
> > Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
> > RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
> > BuffType=unknown, BuffSize=8192kB, MaxMultSect=16, MultSect=16
> > CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=234441648
> > IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
> > PIO modes: pio0 pio1 pio2 pio3 pio4
> > DMA modes: mdma0 mdma1 mdma2
> > UDMA modes: udma0 udma1 udma2
> > AdvancedPM=no WriteCache=enabled
> > Drive conforms to: ATA/ATAPI-6 T13 1410D revision 2:
> >
> > * signifies the current active mode
> >
>
> Was the drive blank when you began? Was/is it the only hard drive
> (including normal IDE HD's) in the system? Right now I'm attempting to
> determine what is different about my system now that it doesn't like it.
> Other than the size difference, that does look like my setup.
>
> Thanks!
I have a cdr on hdc, thats it. It was an OEM drive when I started, but
that was with beta 2 I think. Did a fresh install today of rc2 with out
killing my home partition.
