http://qa.mandrakesoft.com/show_bug.cgi?id=5477
------- Additional Comments From [EMAIL PROTECTED] 2003-10-09 22:14 -------
Output of the commands (cable plugged) :
# ifstatus -v eth0
eth0:
SIOCETHTOOL failed (Operation not supported)
SIOCGMIIPHY: unplugged
SIOCDEVPRIVATE: unplugged
Wireless failed.
# mii-tool -v
eth0: negotiated 100baseTx-FD, link ok
product info: National DP83840A rev 1
basic mode: autonegotiation enabled
basic status: autonegotiation complete, link ok
capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
link partner: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD flow-control
This card seems not to be on the blacklist.
--
Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: NEW
creation_date:
description:
On my computer (see network hardware informations below), ifplugd fails to
initialize my ethernet connection.
dmesg :
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0b.0: 3Com PCI 3c905 Boomerang 100baseTx at 0x9800. Vers LK1.1.18-ac
XX:XX:XX:XX:XX:XX, IRQ 10
product code 4b4b rev 00.0 date 01-04-80
Internal config register is 16302d8, transceivers 0xe040.
8K word-wide RAM 3:5 Rx:Tx split, autoselect/MII interface.
MII transceiver found at address 24, status 786f.
Enabling bus-master transmits and whole-frame receives.
00:0b.0: scatter/gather enabled. h/w checksums disabled
eth0: Dropping NETIF_F_SG since no checksum feature.
messages in LogDrake :
Sep 10 16:09:49 tomlin ifplugd(eth0)[881]: Using interface
eth0/XX:XX:XX:XX:XX:XX with driver <3c59x> (version: LK1.1.18-ac)
Sep 10 16:09:49 tomlin ifplugd(eth0)[881]: Using detection mode: SIOCGMIIPHY
Sep 10 16:09:49 tomlin ifplugd(eth0)[881]: ifplugd 0.15 successfully
initialized, link beat not detected. (NOTE: the cable is connected...)
Sep 10 16:09:49 tomlin network: Bringing up interface eth0 (ifplugd): failed
I can make my connection working by typing "ifup eth0".
A workaround is to append "MII_NOT_SUPPORTED" to
/etc/sysconfig/network-scripts/ifcfg-eth0 : then ifup is used instead of ifplugd
(see /etc/init.d/network).
