Hi,
Did a network install last night from
ftp.rpmfind.net/linux/MandrakeCooker/cooker and the installation went OK
until printer setup, this is when the install hung.
Tried to do an upgrade after restarting the machine, but it doesn't seem
possible to perform an upgrade. Whenever I got to the question of "Do you
have any SCSI interfaces?" I would answer "No" and it would continually say
"Some steps are not completed, do you really want to quit now?". Hitting the
"No" button would repeatedly ask that same question. Whenever I tried to
select any other steps from the left of the screen, I would only receive "An
error occured, not an ARRAY reference". This appeared during all three
installation options. The drive is an 8GB IDE Maxtor.
Another oddity was during X-config. Just after it detected the card and
began downloading XFree, the installer switched to console 1 even though the
download proceeded normally back on console 5. It did this on two separate
occassions, card is a Blaster Banshee.
Kudzu segfaults on startup and Evolution won't start due to errors with
OAF. Other than these few things, I've been using using the system for the
past several hours and it appears quite nice.
Thanks,
--
Phil Lavigna
[EMAIL PROTECTED]
http://www.linux-mandrake.com/en/demos/
