The first part of the install it does install the megaraid module I tried to watch as the modules loaded and I get an error "file not found in archive megaraid.o" then during the hard drive detection it does not appear to see the raid controller because it scans all of the scsi ids and reports finding the 3 drives seperate but aborts because of bad partition table. then it just keeps aborting on all of the ids then finally just locks up. While using a 7.2 install all is fine it loads the megaraid module then during the harddrive detection it sees the raid controller and reports back one large drive size. BTW I did install Redhat 7.0 and 7.1 on this Dell serevr and it installed ok.. It appears that it is loading the qla1280 driver and that might be whats getting in the way. the qla1280 does not load on the 7.2 install. I even loaded the megaraid modules manually before the hard drive detection but it still can't see the raid drives. On Tuesday 17 July 2001 14:41, you wrote: > Ray <[EMAIL PROTECTED]> writes: > > I can't install 8.0 or mandrakefreq 6-19-01 on a Dell server that uses > > the perc 3 raid controller. I have reported this in the 8.0 beta but > > still does not seem to work. It just dies during the hardware detection. > > more info needed... > > what exactly do you mean with ``dies'' ?
