Inline is a pnpdump of a D-Link DE220 isa nic card. It is currently listed within the "Other" field of harddrake but is also listed in the "Network Cards Section" as:
Vendor: Lite-On Communications Inc Model: LNE100TX Kernel Module: tulip Bus Type: PCI Apperantly, since it uses the tulip driver, it get's listed as this card! - Roger -- ----- Verify my pgp/gnupg signature on my HomePage: http://www.alltel.net/~rogerx/about/index.html # $Id: pnpdump_main.c,v 1.27 2001/04/30 21:54:53 fox Exp $ # Release isapnptools-1.26 # # This is free software, see the sources for details. # This software has NO WARRANTY, use at your OWN RISK # # For details of the output file format, see isapnp.conf(5) # # For latest information and FAQ on isapnp and pnpdump see: # http://www.roestock.demon.co.uk/isapnptools/ # # Compiler flags: -DREALTIME -DHAVE_PROC -DENABLE_PCI -DHAVE_SCHED_SETSCHEDULER -DHAVE_NANOSLEEP -DWANT_TO_VALIDATE # # Trying port address 0273 # Board 1 has serial identifier bc 54 27 a0 ba 01 22 8b 11 # (DEBUG) (READPORT 0x0273) (ISOLATE PRESERVE) (IDENTIFY *) (VERBOSITY 2) (CONFLICT (IO FATAL)(IRQ FATAL)(DMA FATAL)(MEM FATAL)) # or WARNING # Card 1: (serial identifier bc 54 27 a0 ba 01 22 8b 11) # Vendor Id DLK2201, Serial Number 1411883194, checksum 0xBC. # Version 1.0, Vendor version 0.0 # ANSI string -->D-Link DE-220P PnP ISA Card<-- # # Logical device id DLK2201 # Device supports I/O range check register # Device supports vendor reserved register @ 0x38 # Device supports vendor reserved register @ 0x3a # Device supports vendor reserved register @ 0x3c # Device supports vendor reserved register @ 0x3d # Device supports vendor reserved register @ 0x3e # # Edit the entries below to uncomment out the configuration required. # Note that only the first value of any range is given, this may be changed if required # Don't forget to uncomment the activate (ACT Y) when happy (CONFIGURE DLK2201/1411883194 (LD 0 # Compatible device id PNP80d6 # Logical device decodes 10 bit IO address lines # Minimum IO base address 0x0240 # Maximum IO base address 0x0380 # IO base alignment 32 bytes # Number of IO addresses required: 32 # (IO 0 (SIZE 32) (BASE 0x0240) (CHECK)) # IRQ 3, 5, 9, 10, 11, 12 or 15. # High true, edge sensitive interrupt # (INT 0 (IRQ 3 (MODE +E))) (NAME "DLK2201/1411883194[0]{D-Link DE-220P PnP ISA Card}") # (ACT Y) )) # End tag... Checksum 0x00 (OK) # Returns all cards to the "Wait for Key" state (WAITFORKEY)
signature.asc
Description: This is a digitally signed message part
