On Wed, 13 Mar 2002 08:21:36 -0600, you wrote: >On Mon, 11 Mar 2002 17:46:09 +0100, you wrote: > >>>>>>> "scott" == Scott Norfleet <[EMAIL PROTECTED]> writes: >> >>scott> Hello Cookerzens, >>scott> I have installed beta4 on a pc that dual boots with Win2000. Its >>scott> network interface is PCI based. Motherboard is a SOYO 5EMH V1.2. The >>scott> network card's configuration utility reports its irq as 10 and Win2000 >>scott> reports it as 11. These appear to not be changeable. Network card is >>scott> fixed at 100 Mb/s and half duplex. Network operations run smoothly >>scott> with LM7.0. When I try to bring up network card with the beta, the pc >>scott> freezes. This happens both with boot time bringing up interface as >>scott> well as gui based startup. What can I do to fix this problem or help >>scott> debug it for the final release? >> >>Could you: >> try to use 3c59x instead of 3c90x driver, and if it works, send >> my way the output of lspci -v? >> >>Later, Juan. > > >Juan, > >Here is the output of lspci-v in the situation that the network >freezes: > > <snip> > >00:08.0 USB Controller: OPTi Inc. 82C861 (rev 10) (prog-if 10 [OHCI]) > Subsystem: OPTi Inc. 82C861 > Flags: bus master, medium devsel, latency 64, IRQ 9 > Memory at d9000000 (32-bit, non-prefetchable) [size=4K] > > <snip> > >>00:0a.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX >[Cyclone] (rev 24) > Subsystem: 3Com Corporation 3C905B Fast Etherlink XL 10/100 > Flags: bus master, medium devsel, latency 64, IRQ 10 > I/O ports at 1000 [size=128] > Memory at 10000000 (32-bit, non-prefetchable) [size=128] > Expansion ROM at <unassigned> [disabled] [size=128K] > Capabilities: <available only to root> > > >I hope to later today reinstall and tell it that the NIC is is 3c595. >It did not appear to want me to change it with the control center. >It did say that is was using the 3c59x kernel module. >Thanks for your assistance! >Scott
P.S. Would not let me tell it that it was specifically a 3c595. Tonight's install produced these changes on 3c905B I/O ports at e800 [size=128] <<<< Now correct I think matches Win2000 Memory at d9001000 (32-bit, non-prefetchable) [size=128] <<<< ???
