Warly writes: > Mikko Huhtala <[EMAIL PROTECTED]> writes: > > machine is booted after install, cardmgr comes up and seems to be > > running, but no cards are detected. I have a network card in one slot > > and a modem in the other. If I eject one or the other card, the system > > hangs immediately.
> > try to boot with devfs=nomount and test if that works > -- > Warly In dmesg kernel card services say PCI: No IRQ known for interrupt pin A of device 00:02.0. PCI: No IRQ known for interrupt pin B of device 00:02.1. Yenta IRQ list 06b8, PCI irq0 Socket status: 30000011 Yenta IRQ list 06b8, PCI irq0 Socket status: 30000011 So it seems that IRQs do not get assigned correctly, but I suspect this is only a symptom of actual problem. I tried with 'devfs=nomount' as well as 'pci=biosirq' (recommended by cardmgr) both separately and together. The problem presists. My case seems to be a bit different from the one reported elsewhere in this thread in that if I boot without the cards and then plug one (does not matter which one) in when the system is up and cardmgr is running, the system does hang. Mikko
