Have you tried: 1) boot with DOS boot disk 2) use the disk that came with that card and run the configuration program 3) warm reboot to Linux
? --- Mustafa Celik <[EMAIL PROTECTED]> wrote: > Hello, > I think I've got some IRQ issues with 3com 3c509TP > ISA ethernet card on > Mandrake 9.0 beta. > > I have installed linux as dual boot. I've got Nortel > 1Meg DSL modem hooked > up to my ethernet card. On PC my ethernet card is > recognized and works very > well at IRQ 9, I/O: 0x#300 . However, it is not > recognized at Linux: > > 1.) HardDrake (a h/w probing tool at Mandrake) can > not detect my ethernet > device!? > > 2.) Device drivers are installed properly, eth0 is > there when I do > "ifconfig", I can ping it, shows up as up and > running. Tx packets are > incrementing when I do "adsl-connect", but Rx never > increases... I see > "Timeout on PADO packets" log after a while. > > It might be my ISP not responding to my connect > request at all, but I could > not see any activity on my DSL modem's LEDs when I > start the "adsl-connect". > So, I am more suspicious about an internal problem, > probably an IRQ > conflict? > > I think my ISA ethernet device is set as IRQ 9, and > another PCI device is > overwriting this setup. I have checked > /proc/interrupts, IRQ 9 never > increments, but other IRQ's are incerementing every > once in a while. What's > going on here? > > Mustafa > > _________________________________________________________________ > Chat with friends online, try MSN Messenger: > http://messenger.msn.com > > __________________________________________________ Do You Yahoo!? Yahoo! Health - Feel better, live better http://health.yahoo.com
