I installed Beta 3 and have some issues to point out about the install. Here is the hardware setup.
Motherboard: Asus A7V266 AMD 1.4 Ghz Thunderbird 266FSB Memory: 1GB DDR SDRAM SCSI Controller: Adaptec 29160 PCI Hard Drives: 2 9GB Ultra 2 Drives Video Card: Leadtek Geforce3 TI200 128 MB Modem: US Robotics Internal PCI Monitor: Nokia 447XiPlus Keyboard: IBM Rapid Access USB Mouse : Microsoft USB Wheel Optical The install locks up once I get to the standard install screen. This also happenend with 8.2. The screen just goes black and quits. However the F1 vga16 alternative works. Unlike 8.2, the installation routine recognizes the IBM keyboard which is a nice improvement. But it seems very important to be able to use the standard installation method with this hardware. People may not be clued in to the vga16 alternative so if you guys can correct this it would be great. Otherwise the install went fine except for some unresolved symbols in one video module which doesn't affect the boot process that I can see. Both KDE and Gnome seem to run very crisply. It looks very promising. Bob Rossana -- **************************************************************** Robert J. Rossana E-Mail: [EMAIL PROTECTED] Department of Economics, 2074 FAB Wayne State University, Detroit MI 48202 Tel.: (313) 577-3760 Fax: (313) 577-0149 Web Page: www.econ.wayne.edu/~rossana ****************************************************************
