I'm resending this message since my first attempt failed (rejected because the log files I attached where too large).
Just installed RC3 on my (SMP) box and found the following bugs: 1. install.log reports that %post failed while installing glibsc (rm command not found). 2. I reformatted partitions originally created for RC2. / is mounted from /dev/hda12 (ReiserFS), while /usr, /var, /tmp and /home are mounted from LVM partitions (XFS). mkfs.xfs reports that it could not find the lvdisplay command (see in ddebug.log). 3. On booting RC3 it reported an error in /etc/init.d/usb (line 1: eval not found). This is early on in the boot process, just after the host name is set, but before the LVM volumes are mounted (I think). 4. On shutting down the system I briefly saw a message in which the VFS seemed to say that some inode where still open. The system still shut down OK. Not sure what these messages meant, and they appeared and disappered so quickly I was not able to work out excatly what they said. (these ones are newer than my original list) 5. I had a USB wheel mouse plugged into a port on my hub, however it could not be seen from there. Plugging it directly into the USB port on my box meant that it could be seen (after restarting X). Note however that the installer could see my USB mouse when it was in the hub. Also note that everything worked fine for RC.2. 6. Mouse stopped working after 10 minutes or so, I had to go to run level 3, unload the hid module, reload it and go back to run level 5. Other than these problems everything is looking fine. I'm going to have another try at installing over this weeknd using a different setup to see what I get. Alan
