Juan Quintela wrote:
franco> .....there isn't no /thermal_zone and neither /processor.......
franco> in lsmod there is:
franco> [...]
franco> thermal 7136 0 (unused)
franco> processor 9112 0 [thermal]
franco> [...]
same here
Send dmesg output after doing all the insertions, please.
Later, Juan.
Removing and modprobing again the modules made nothing appear in dmesg
but I joined it if you can see something else ...
Linux version 2.4.20-0.1mdk ([EMAIL PROTECTED]) (gcc version 3.2 (Mandrake
Linux 9.1 3.2-3mdk)) #1 Wed Nov 20 12:01:15 CET 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e3000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000017ff0000 (usable)
BIOS-e820: 0000000017ff0000 - 0000000017fffc00 (ACPI data)
BIOS-e820: 0000000017fffc00 - 0000000018000000 (ACPI NVS)
BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
383MB LOWMEM available.
ACPI: have wakeup address 0xc0001000
On node 0 totalpages: 98288
zone(0): 4096 pages.
zone(1): 94192 pages.
zone(2): 0 pages.
ACPI: RSDP (v000 HP-MCD ) @ 0x000f6c70
ACPI: RSDT (v001 HP-MCD FA RSDT 00272.00000) @ 0x17ff59dc
ACPI: FADT (v001 HP-MCD FA FACP 00272.00000) @ 0x17ff5a08
ACPI: BOOT (v001 PTLTD FABFTBL$ 00272.00000) @ 0x17fffbd8
ACPI: DSDT (v001 HP-MCD FA DSDT 00272.00000) @ 0x00000000
ACPI: BIOS passes blacklist
ACPI: MADT not present
Kernel command line: BOOT_IMAGE=acpi ro root=308
Local APIC disabled by BIOS -- reenabling.
Could not enable APIC!
Initializing CPU#0
Detected 696.983 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1389.36 BogoMIPS
Memory: 386188k/393152k available (1277k kernel code, 6576k reserved, 486k data, 140k
init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount-cache hash table entries: 8192 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 0a
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch ([EMAIL PROTECTED])
mtrr: detected mtrr type: Intel
ACPI: Subsystem revision 20021022
PCI: PCI BIOS revision 2.10 entry at 0xfd99d, last bus=1
PCI: Using configuration type 1
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: System [ACPI] (supports S0 S1 S3 S4 S5)
ACPI: PCI Interrupt Link [LNKA] (IRQs *10)
ACPI: PCI Interrupt Link [LNKB] (IRQs *10)
ACPI: PCI Interrupt Link [LNKC] (IRQs 15, disabled)
ACPI: PCI Interrupt Link [LNKD] (IRQs *5)
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.AGP_._PRT]
ACPI: Embedded Controller [EC0] (gpe 0)
PCI: Probing PCI hardware
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 15
PCI: Using ACPI for IRQ routing
PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off'
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
apm: overridden by ACPI.
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
devfs: v1.12c (20020818) Richard Gooch ([EMAIL PROTECTED])
devfs: boot_options: 0x0
vesafb: framebuffer at 0xf5000000, mapped to 0xd8810000, size 8128k
vesafb: mode is 1024x768x16, linelength=2048, pages=4
vesafb: protected mode interface info at c000:5010
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Looking for splash picture.... found (1024x768, 37885 bytes).
Console: switching to colour frame buffer device 80x16
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ
SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
Applicom driver: $Id: ac.c,v 1.30 2000/03/22 16:03:57 dwmw2 Exp $
ac.o: No PCI boards found.
ac.o: For an ISA board you must supply memory and irq parameters.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:DMA, hdb:pio
hda: FUJITSU MHM2200AT, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
blk: queue c030a2ac, I/O limit 4095Mb (mask 0xffffffff)
hda: 39070080 sectors (20004 MB) w/2048KiB Cache, CHS=2584/240/63, UDMA(33)
Partition check:
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 < p5 p6 p7 p8 >
RAMDISK driver initialized: 16 RAM disks of 32000K size 1024 blocksize
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 120k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 140k freed
Real Time Clock Driver v1.10e
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 12:37:16 Nov 20 2002
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0x1020, IRQ 5
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usbdevfs: remount parameter error
hub.c: new USB device 00:07.2-1, assigned address 2
hub.c: USB hub found
hub.c: 3 ports detected
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,8), internal journal
hub.c: new USB device 00:07.2-1.2, assigned address 3
Adding Swap: 249440k swap-space (priority -1)
usb.c: USB device 3 (vend/prod 0x46d/0xc012) is not claimed by any active driver.
usb.c: registered new driver usb_mouse
input0: Logitech USB-PS/2 Optical Mouse on usb1:3.0
usbmouse.c: v1.6:USB HID Boot Protocol mouse driver
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <[EMAIL PROTECTED]>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
ACPI: Battery Slot [BAT1] (battery present)
ACPI: Battery Slot [BAT2] (battery absent)
ACPI: Battery Slot [BAT3] (battery absent)
ACPI: AC Adapter [ACAD] (on-line)
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,7), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,5), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
MSDOS FS: IO charset iso8859-15
MSDOS FS: Using codepage 850
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
00:0b.0: 3Com PCI 3c556 Laptop Tornado at 0x1400. Vers LK1.1.16
Linux Kernel Card Services Kernel Version
options: [pci] [cardbus] [pm]
Yenta IRQ list 0898, PCI irq10
Socket status: 30000006
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x398-0x39f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
Installing knfsd (copyright (C) 1996 [EMAIL PROTECTED]).
maestro3: version 1.23 built at 12:34:17 Nov 20 2002
maestro3: Configuring ESS Maestro3(i) found at IO 0x1C00 IRQ 5
maestro3: subvendor id: 0x0011103c
ac97_codec: AC97 Audio codec, id: ��v9(SigmaTel STAC9721/23)
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]
parport0: irq 7 detected
lp0: using parport0 (polling).
