https://qa.mandrakesoft.com/show_bug.cgi?id=1004
Product: Installation
Component: Installation
Summary: Summary install page, printer button loop
Version: 1.770
Platform: PC
OS/Version: All
Status: UNCONFIRMED
Severity: normal
Priority: P2
AssignedTo: [EMAIL PROTECTED]
ReportedBy: [EMAIL PROTECTED]
beta-2 Install
Blank HD nothing else on it.
Running installer in the auto mode.
Reached the 'summary' section ...
Printer button shows 'CUPS'.
Clicked on button, expecting to get the install info about the printer.
Instead the printer installer ran and installed the printer???
Leaving me to think what is going on. I expected choices to
be presented, not install to take place.
Install printer ends with the dialog asking if I want to auto-start the
printing system at boot. Select Yes.
Asks for CD1,
Put in CD1,
Click OK,
Asks again for __SAME CD1__
Do it again,
Asks again for __SAME CD1__
This time click cancel
__LOOP__ appears to end. Not clear what is happening.
Next ...
Dialog asking to auto configure printers,
Auto-detect check box selected,
Click Next,
Dialog box displays, no printers found click Ok, (no printers on system)
Dialog asking to auto-detect printers, same as before,
___loops, no end___
Finally click Previous button
Summary button list re-appears.
Printer button now displays 'Remote CUPS server'
The trigger event was to select the printer from the installer summary page
button list.
Network button on summary page, worked properly, installed eth(0) LAN.
At this point proceeded with install. New system runs at boot.
Repeatable with my configuration.
This is a re-write and re-test for an incorrect bug submission #988
snooker
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
