https://qa.mandrakesoft.com/show_bug.cgi?id=1881
------- Additional Comments From [EMAIL PROTECTED] 2003-02-23 23:10 ------- Bug still present in drakxtools 9.1-4 I have tested with an Orinoco wireless card, and a 3Com Fast Ethernet card. Any changes made to any parameter in the drakconnect Wizard are applied when the 'Finish' button is pressed, and then discarded again when the 'OK' button is used to exit the GUI. On re entering drakconnect the old parameters are still set. This behaviour is also present in Mandrake 9.0 ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: UNCONFIRMED creation_date: description: 9.1RC1 Example failure scenario :- /etc/sysconfig/network-scripts/ifcfg-eth0 is set up for an pcmcia Ethernet card, but the user is replacing the Ethernet card with a wireless card. The user starts mcc and selects the networking GUI. The user presses the 'Wizard' button and goes through drakconnect to set up the wireless card parameters. On pressing 'Finish' to exit the wizard the new parameters are used to set up the card, and it starts working. The user then presses 'OK' in the networking GUI, and the original contents of ifcfg-eth0 are then written back again and the card stops working. The user has to exit the GUI with 'Cancel' in order to retain the modified contents of ifcfg-eth0. This is obviously not very intuitive.
