a a schrieb: > Ludwig Jaffe wrote: > > Hi > > > > yes, I will check the jumper to unprotect the flash. > > Accourding to an1122 this should be the "temporary unprotect" > > by rising pin1 to 12V=VID. > > The block-unprotect algorithm (protect all blocks, then unprotect all) > > should be added to flashrom aswell so we can permanently unprotect the > > flash. > > jep done that .. but i think you did also ?
No, not yet. That is work to do. Soldering-in the jumper is not the big deal btw. > > > > Greetings > > > > LuJa > > > > > > > > a a schrieb: > >> Ludwig Jaffe wrote: > >>> Hi, > >>> > >>> looking for the unprotect-algorithm I found the AN1122 from ST. > >>> The figure 4 shows a way to do this, but, how do we put VID=12V to > >> Pin#1? > >>> Does anybody know how this is done or if we should use the > >>> programmer-mode/way instaed of insystem/mode/way? > >>> > >>> Thanks for your comments. > >>> > >>> Attached the application-note, and the datasheet of st29F002B series. > >>> > >>> > >>> Greetings > >>> > >>> LuJa > >>> > >>> > >> from the other tread i assume you are talking about the > >> compaq deskpro en sff 600n motherboard which has a jumper (P34 but not > >> mounted only pads) to connect pin1 to 12Vdc > >> > >> > >> > ------------------------------------------------------------------------ > >> Express yourself instantly with MSN Messenger! MSN Messenger > >> > > > > > > > > > > ------------------------------------------------------------------------ > Express yourself instantly with MSN Messenger! MSN Messenger > <http://clk.atdmt.com/AVE/go/onm00200471ave/direct/01/> -- coreboot mailing list [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
