Hi //Peter
Why the restrictions on who you can sell to ?
How about US consumers ? You didn't mention them on your page ?
Bob
----- Original Message -----
From: "Peter Stuge" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, July 17, 2008 1:21 PM
Subject: Re: [coreboot] GA-M57SLI-S4 rev 2.0 dual flash chip
modificationrecipe
When testing a modified board a while back I discovered that I had
forgoten one important ingredient and step in this recipe. I've just
updated http://stuge.se/m57sli/ and added a photo of the finished mod
while I was at it.
On Sun, Jun 22, 2008 at 07:24:45AM +0200, Peter Stuge wrote:
For the better modification, you also need:
2x 0402 4k7 chip resistors (1k is OK too, 10k does not work!)
2x 0603 100k chip resistors
2x SOT-23 BC847C transistors
Add:
1cm AWG 30 wire (but get some extra so there is some to work with)
Better:
NOTE: Switch wires can be rather long. Several meters has been tested.
4. R90,R91: Populate 0402 4k7 resistors
Insert:
5. Q2,Q43: Solder 5mm or so of AWG 30 wire between Q2-2 and Q2-3.
Solder another wire between Q43-2 and Q43-3.
I am happy to sell boards pre-modified with the better modification.
Unfortunately I cannot offer these boards to consumers in all EU
member states because of EU environmental regulations, but many are
OK.
I've made a table showing which states I can sell to on the web page
too.
//Peter
--
coreboot mailing list
[email protected]
http://www.coreboot.org/mailman/listinfo/coreboot
--
coreboot mailing list
[email protected]
http://www.coreboot.org/mailman/listinfo/coreboot
