I'm attaching the config dumps for v2 and v3. I've modified the v2 dump by taking out the subsystem vendor and device IDs because I don't think they affect functionality and they confuse the issue.
There are relatively few differences left, but I'm not sure what's the most important one. Some of the differences are: 1. v2 sets interrupts, v3 doesn't (when and where should that happen?) 2. v2 enables the other core in the Opteron, v3 doesn't yet (low priority for now) It looks like the bridges are all set up correctly, but the VGA area 0xa0000-0xbffff isn't getting to the VGA card (If you look at the other mapping, it's not updated) The current status is: - Coreboot boots to the payload - VGA ROM is run - Screen turns black (initializes) (that means that the VGA IOs in the 0x3xx range are getting there.) - No output on screen Thanks, Myles
v3.now.pci
Description: Binary data
v2.log.pci.noid
Description: Binary data
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
