Add CONFIG_VGA_ROM_RUN to dbm690t and pistachio, otherwise the
VGA ROM can not run. After make, run
> ./cbfs/cbfstool ./coreboot.rom add ../vga_bios.rom   pci1002,791f.rom
optionrom
to make the final image with vga bios.

The macro vga_rom_address is out-of-date when CBFS starts play its role.
it also should
be eliminated from rs690/chip.h as below. But it will cause building
error on other board, which I
can not make test on.

##    Index: src/southbridge/amd/rs690/chip.h
##
===================================================================
##    --- src/southbridge/amd/rs690/chip.h      (revision 4782)
##    +++ src/southbridge/amd/rs690/chip.h      (working copy)
##    @@ -23,7 +23,6 @@
##     /* Member variables are defined in Config.lb. */
##     struct southbridge_amd_rs690_config
##     {
##    - u32 vga_rom_address;            /* The location that the VGA rom
has been appened. */
##      u8 gpp_configuration;   /* The configuration of General Purpose
Port, A/B/C/D/E. */
##      u8 port_enable;         /* Which port is enabled? GFX(2,3),
GPP(4,5,6,7) */
##      u8 gfx_dev2_dev3;       /* for GFX Core initialization
REFCLK_SEL */
##

Don't apply the above patch about rs690/chip.h before every board has
fixed.

Signed-off-by: Zheng Bao <[email protected]>



Index: src/southbridge/amd/rs690/rs690_gfx.c
===================================================================
--- src/southbridge/amd/rs690/rs690_gfx.c       (revision 4782)
+++ src/southbridge/amd/rs690/rs690_gfx.c       (working copy)
@@ -77,13 +77,9 @@
            (struct southbridge_amd_rs690_config *)dev->chip_info;
        deviceid = pci_read_config16(dev, PCI_DEVICE_ID);
        vendorid = pci_read_config16(dev, PCI_VENDOR_ID);
-       printk_info("internal_gfx_pci_dev_init device=%x, vendor=%x,
vga_rom_address=0x%x.\n",
-            deviceid, vendorid, cfg->vga_rom_address);
+       printk_info("internal_gfx_pci_dev_init device=%x, vendor=%x.\n",
+            deviceid, vendorid);
 
-#if 0 /* I think these should be done in Config.lb. Please check it. */
-       dev->on_mainboard = 1;
-       dev->rom_address = cfg->vga_rom_address;        /* 0xfff00000;
*/
-#endif
        pci_dev_init(dev);
 
        /* clk ind */
Index: src/mainboard/amd/dbm690t/Options.lb
===================================================================
--- src/mainboard/amd/dbm690t/Options.lb        (revision 4782)
+++ src/mainboard/amd/dbm690t/Options.lb        (working copy)
@@ -73,6 +73,7 @@
 uses CONFIG_OBJCOPY
 uses CONFIG_CONSOLE_VGA
 uses CONFIG_PCI_ROM_RUN
+uses CONFIG_VGA_ROM_RUN
 uses CONFIG_HW_MEM_HOLE_SIZEK
 uses CONFIG_HT_CHAIN_UNITID_BASE
 uses CONFIG_HT_CHAIN_END_UNITID_BASE
@@ -103,8 +104,6 @@
 ##
 ## CONFIG_FALLBACK_SIZE is the amount of the ROM the complete fallback
image will use
 ##
-#default CONFIG_FALLBACK_SIZE = CONFIG_ROM_IMAGE_SIZE
-#256K
 default CONFIG_FALLBACK_SIZE = CONFIG_ROM_IMAGE_SIZE
 
 ##
@@ -160,6 +159,7 @@
 #VGA Console
 default CONFIG_CONSOLE_VGA=1
 default CONFIG_PCI_ROM_RUN=1
+default CONFIG_VGA_ROM_RUN=1
 
 # BTDC: Only one HT device on Herring.
 #HT Unit ID offset
Index: src/mainboard/amd/dbm690t/Config.lb
===================================================================
--- src/mainboard/amd/dbm690t/Config.lb (revision 4782)
+++ src/mainboard/amd/dbm690t/Config.lb (working copy)
@@ -136,7 +136,6 @@
 #The variables belong to mainboard are defined here.
 
 #Define gpp_configuration,     A=0, B=1, C=2, D=3, E=4(default)
-#Define vga_rom_address = 0xfff0000
 #Define port_enable, (bit map): GFX(2,3), GPP(4,5,6,7)
 #Define gfx_dev2_dev3, 0: a link will never be established on Dev2 or
Dev3,
 #                                         1: the system allows a PCIE
link to be established on Dev2 or Dev3.
@@ -170,7 +169,6 @@
                                        device pci 6.0 on end # PCIE P2P
bridge 0x7916
                                        device pci 7.0 on end # PCIE P2P
bridge 0x7917
                                        device pci 8.0 off end # NB/SB
Link P2P bridge
-                                       register "vga_rom_address" =
"0xfff00000"
                                        register "gpp_configuration" =
"4"
                                        register "port_enable" = "0xfc"
                                        register "gfx_dev2_dev3" = "1"
Index: src/mainboard/amd/dbm690t/devicetree.cb
===================================================================
--- src/mainboard/amd/dbm690t/devicetree.cb     (revision 4782)
+++ src/mainboard/amd/dbm690t/devicetree.cb     (working copy)
@@ -1,5 +1,4 @@
 #Define gpp_configuration,     A=0, B=1, C=2, D=3, E=4(default)
-#Define vga_rom_address = 0xfff0000
 #Define port_enable, (bit map): GFX(2,3), GPP(4,5,6,7)
 #Define gfx_dev2_dev3, 0: a link will never be established on Dev2 or
Dev3,
 #                      1: the system allows a PCIE link to be
established on Dev2 or Dev3.
@@ -33,7 +32,6 @@
                                        device pci 6.0 on end # PCIE P2P
bridge 0x7916
                                        device pci 7.0 on end # PCIE P2P
bridge 0x7917
                                        device pci 8.0 off end # NB/SB
Link P2P bridge
-                                       register "vga_rom_address" =
"0xfff00000"
                                        register "gpp_configuration" =
"4"
                                        register "port_enable" = "0xfc"
                                        register "gfx_dev2_dev3" = "1"
Index: src/mainboard/amd/pistachio/Options.lb
===================================================================
--- src/mainboard/amd/pistachio/Options.lb      (revision 4782)
+++ src/mainboard/amd/pistachio/Options.lb      (working copy)
@@ -73,6 +73,7 @@
 uses CONFIG_OBJCOPY
 uses CONFIG_CONSOLE_VGA
 uses CONFIG_PCI_ROM_RUN
+uses CONFIG_VGA_ROM_RUN
 uses CONFIG_HW_MEM_HOLE_SIZEK
 uses CONFIG_HT_CHAIN_UNITID_BASE
 uses CONFIG_HT_CHAIN_END_UNITID_BASE
@@ -158,6 +159,7 @@
 #VGA Console
 default CONFIG_CONSOLE_VGA=1
 default CONFIG_PCI_ROM_RUN=1
+default CONFIG_VGA_ROM_RUN=1
 
 # BTDC: Only one HT device on Herring.
 #HT Unit ID offset
Index: src/mainboard/amd/pistachio/Config.lb
===================================================================
--- src/mainboard/amd/pistachio/Config.lb       (revision 4782)
+++ src/mainboard/amd/pistachio/Config.lb       (working copy)
@@ -136,7 +136,6 @@
 #The variables belong to mainboard are defined here.
 
 #Define gpp_configuration,     A=0, B=1, C=2, D=3, E=4(default)
-#Define vga_rom_address = 0xfff0000
 #Define port_enable, (bit map): GFX(2,3), GPP(4,5,6,7)
 #Define gfx_dev2_dev3, 0: a link will never be established on Dev2 or
Dev3,
 #                                         1: the system allows a PCIE
link to be established on Dev2 or Dev3.
@@ -171,7 +170,6 @@
                                        device pci 6.0 on end # PCIE P2P
bridge 0x7916
                                        device pci 7.0 on end # PCIE P2P
bridge 0x7917
                                        device pci 8.0 off end # NB/SB
Link P2P bridge
-                                       register "vga_rom_address" =
"0xfff00000"
                                        register "gpp_configuration" =
"4"
                                        register "port_enable" = "0xfc"
                                        register "gfx_dev2_dev3" = "1"
Index: src/mainboard/amd/pistachio/devicetree.cb
===================================================================
--- src/mainboard/amd/pistachio/devicetree.cb   (revision 4782)
+++ src/mainboard/amd/pistachio/devicetree.cb   (working copy)
@@ -1,5 +1,4 @@
 #Define gpp_configuration,     A=0, B=1, C=2, D=3, E=4(default)
-#Define vga_rom_address = 0xfff0000
 #Define port_enable, (bit map): GFX(2,3), GPP(4,5,6,7)
 #Define gfx_dev2_dev3, 0: a link will never be established on Dev2 or
Dev3,
 #                      1: the system allows a PCIE link to be
established on Dev2 or Dev3.
@@ -34,7 +33,6 @@
                                        device pci 6.0 on end # PCIE P2P
bridge 0x7916
                                        device pci 7.0 on end # PCIE P2P
bridge 0x7917
                                        device pci 8.0 off end # NB/SB
Link P2P bridge
-                                       register "vga_rom_address" =
"0xfff00000"
                                        register "gpp_configuration" =
"4"
                                        register "port_enable" = "0xfc"
                                        register "gfx_dev2_dev3" = "1"
Index: targets/amd/dbm690t/Config.lb
===================================================================
--- targets/amd/dbm690t/Config.lb       (revision 4782)
+++ targets/amd/dbm690t/Config.lb       (working copy)
@@ -4,7 +4,7 @@
 mainboard amd/dbm690t
 
 romimage "normal"
-       option CONFIG_ROM_SIZE = 1024*1024 - 55808
+       option CONFIG_ROM_SIZE = 1024*1024
        option CONFIG_USE_FALLBACK_IMAGE=0
        option CONFIG_ROM_IMAGE_SIZE=0x20000
        option CONFIG_XIP_ROM_SIZE=0x20000
Index: targets/amd/pistachio/Config.lb
===================================================================
--- targets/amd/pistachio/Config.lb     (revision 4782)
+++ targets/amd/pistachio/Config.lb     (working copy)
@@ -4,14 +4,14 @@
 mainboard amd/pistachio
 
 romimage "normal"
-       option CONFIG_ROM_SIZE = 1024*1024 - 55808
+       option CONFIG_ROM_SIZE = 1024*1024
        option CONFIG_USE_FALLBACK_IMAGE=0
        option CONFIG_ROM_IMAGE_SIZE=0x20000
        option CONFIG_XIP_ROM_SIZE=0x20000
        payload ../payload.elf
 end
 
-romimage "fallback" 
+romimage "fallback"
        option CONFIG_USE_FALLBACK_IMAGE=1
        option CONFIG_ROM_IMAGE_SIZE=0x20000
        option CONFIG_XIP_ROM_SIZE=0x20000

Attachment: dbm690t_run_vga_rom_with_cbfs.patch
Description: dbm690t_run_vga_rom_with_cbfs.patch

-- 
coreboot mailing list: [email protected]
http://www.coreboot.org/mailman/listinfo/coreboot

Reply via email to