On Thu, May 13, 2010 at 10:42:40AM -0400, Stefan Reinauer wrote: > the MCP55 azalia init code is kind of crude. I fixed the code for ICH7 a > while ago and now I ported my version of the Azalia code to MCP55 / > H8DME (assuming that's the board target you use for the H8DME-2) > Can you please see if this is any better than before? It's likely that > the verb table won't match the codec used on that board, but there only > was a single codec in the mcp55 driver and the used codec is usually > mainboard dependent, not chipset dependent.
It works!!! But I didn't hear a beep during coreboot. Was I supposed to? Regards, and thanks, Joe -- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
