hi Joop, From the log, the filo worked fine. it can detect the hard disk,load kernel. But the kernel crashes. i do not not much about why it crashed, how about try to disable acpi?
On Wed, May 19, 2010 at 2:11 PM, Joop Boonen <[email protected]> wrote: > On Wed, May 19, 2010 1:46 am, [email protected] wrote: > > Hi > > Grub command is fine, what is your problem about filo? send the log if > > you can > > The problem is that I see the follwoing in the log: > > <quote> > Jumping to entry point... > > > > INIT detected from --- { APICID = 00 NODEID = 00 COREID = 00} --- > > Issuing SOFT_RESET... > </quote> > > I've also attached the log. > > > > > Wang Qing Pei > > Mail: [email protected] > > Phone:86+013426369984 > > > > > > ----- Reply message ----- > > 发件人： "Joop Boonen" <[email protected]> > > 日期： 周三, 5 月 19 日, 2010 年 07:09 > > 主题： [coreboot] Advice how to install Linux to get it working with > > FILO > > 收件人： <[email protected]> > > > > Hello All, > > > > I want to get FILO working on my system (arima/hdama). > > As I want to rule out my Linux installation I have a few questions. > > I've installed openSuSE 11.2 x86_64 on a SATA disk connected to the on > > board SIL3114 controller. > > > > I have the follwoing partitioning. > > 1) /boot about 128 MB > > 2) swap about 2 GB > > 3) /root about 60GB > > 4) /home about 20GB > > > > Is this OK or is there also a track maximum for FILO like existed for > > LILO? > > Is it best to configure FILO with grub commands? > > > > Regards, > > > > Joop. > > > > > > -- > > coreboot mailing list: [email protected] > > http://www.coreboot.org/mailman/listinfo/coreboot > > -- > > coreboot mailing list: [email protected] > > http://www.coreboot.org/mailman/listinfo/coreboot > -- Wang Qing Pei MSN:[email protected] <msn%[email protected]> Gmail:[email protected] <gmail%[email protected]> Phone:86+13426369984
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
