29.06.2010 15:46, Jason Self пишет:
Indeed; I've never soldered/desoldered anything in my life. I thought
that Flashrom was used to get Coreboot onto the board. I clearly
misunderstand the purpose of Flashrom if physical modification is also
needed. If that's specific to the M2A-VM perhaps I should look for a
different Micro ATX board with which I can use Flashrom. Suggestions?
You can brick your board if something goes wrong. So it's recommended to
use 'top hat' tool (simply 2 PLCC panels, that are connected pin-to-pin,
except, as I remember, CS signal) - that allows to place new chip over
soldered one, and safely use new chip for experiments - and if something
goes wrong, just remove 'top hat' and get system with original BIOS.
P.S. Soldering is easy by hot air that heating bottom of PCB -
300..350C. + of course flux. And it's ideal to have in this case
two-side heating - ftom top and bottom; solder becomes liquid for 2-3
minutes...
--
coreboot mailing list: [email protected]
http://www.coreboot.org/mailman/listinfo/coreboot
