Quoting Stefan Reinauer <[email protected]>: > On 8/1/10 7:13 AM, [email protected] wrote: >> Hi. >> The wiki page for seabios recommends configuring coreboot with >> CONFIG_VGA_BRIDGE_SETUP enabled and CONFIG_VGA_ROM_RUN disabled. >> >> When building for the jetway j7f24 target, setting those two options >> in menuconfig results in the following error (after "make"): >> >> >> CC cpu/intel/microcode/microcode.o >> AR coreboot.a >> CC coreboot_ram.o >> CC coreboot_ram >> build/coreboot_ram.o: In function `vga_init': >> vga.c:(.text+0x1968): undefined reference to >> `mainboard_interrupt_handlers' >> collect2: ld returned 1 exit status >> make: *** [build/coreboot_ram] Error 1 >> >> With both options enabled make finishes. I don't know much about >> kconfig, so I haven't been able to figure out where the problem is. >> >> Here is my .config > > You also need to disable CONFIG_PCI_ROM_RUN. > > The behavior here was slightly changed over time, so we probably should > fix the documentation. We should also fix the code. Compilation errors > are not so nice. > > Stefan
Yes, the documentation does say to disable CONFIG_PCI_ROM_RUN, which I did, but I didn't mention that because it seemed irrelevant. After trying different combinations, I see make fails when CONFIG_VGA_BRIDGE_SETUP is enabled and both CONFIG_PCI_ROM_RUN and CONFIG_VGA_ROM_RUN are disabled (the recommended combination), but works if either _ROM_RUN option is enable. Should be fairly simple to fix, so I guess it's time for me to learn how kconfig works. Rob Austin
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
