These sockets are good because their pins are hard to bend, so I used it on the bottom of the "pie": http://rocky.digikey.com/weblib/Mill-Max/Web%20Photos/110-13-632-41-001000.jpg
This ones pins are easier to bend, so I used them to bend Chip Enable pins. http://www.buyicnow.com/pic/SOCKET/P00001177.jpg If part is deselected (Chip Enable floating), Chip Enable pin should be high, but my flash part doesn't have internal pull-ups, so sometimes during flashing deselected chip was badly flashed. I soldered external 200 kilohm resistors to pull-up both Chip Enable pins. Now it works for me :) I hope someone will have time to update wiki :) Thanks, Tadas
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
