I am trying (again) to get the Adaptec SCSI on my P2B-LS to initialize properly with coreboot. But it won't boot.
Attached is a serial log of what happened. After compiling coreboot I checked out SeaBIOS through git and added the SCSI option rom extracted from my factory bios. A port and a few other resources is assigned, but no IRQ. The SCSI option rom would initialize, I can press the hotkey to enter the utility, but that's it. That option rom hangs before getting any responses from the SCSI hardware. I am trying to set up SerialICE to see what is going on. Just looking for some insights before I reach that point. I have to jumper off the SCSI to get it to boot. I don't know if this has anything to do but the Ultra2 port on my other P2B-LS is fubared and nothing plugged there would register. Afraid the same may befall this board too. Thanks Keith
p2bls.scsi.log
Description: Binary data
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
