Hi, thanks! Now 2 strange things happen for both suggestions: 2011/10/26 Kyösti Mälkki <[email protected]>
> > reg32 = sch_port_access_read(4, 0x71, 2); > reg32 &= 0x700; > reg32 = reg32 >> 7; > > Probably should read: > reg32 &= 0x700; > reg32 = reg32 >> 8; > ------------ Serial output ------------ US15W Chipset Unknown (07)Setting up ACPI PM1 block Setting up ACPI P block done. Setting up RAM controller. READ BASE_ADDR=fffc0000 Setting up RAM Setting up RAM Setting up RAM -- continuously prints "Setting up RAM" line.. Ok I get passed the "Setting up RAM controller." now, but stuck now in "Setting up RAM" as can be seen above I print the detected softstrap base, and it says fffc0000. > or (not so likely) > reg32 &= 0x380; > reg32 = reg32 >> 7; > And for this the same happens with fffe0000 address detected as softstrap base? ------------ Serial output ------------ US15W Chipset Unknown (07)Setting up ACPI PM1 block Setting up ACPI P block done. Setting up RAM controller. READ BASE_ADDR=fffe0000 Setting up RAM Setting up RAM Setting up RAM -- continuously prints "Setting up RAM" line.. I didn't get what's going on. So which one is correct to use? But both are stuck at "Setting up RAM" line.. Thanks in advance, Alp
-- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
