Hi Martin, Autoport wasn't much use to me since it didn't recognize anything. However it left behind all kinds of logs like the full lspci output and stuff like that -> that's why I shared it.
https://github.com/rnplus/test-coreboot-for-asus-p5g41t-m-lx/blob/maste r/superiodump https://github.com/rnplus/test-coreboot-for-asus-p5g41t-m-lx/blob/maste r/superioextradump This is the output of superiotool using the OEM BIOS. The SIO is configured for 0x2E. Greetings, Renze On Mon, 2016-03-21 at 13:47 -0600, Martin Roth wrote: > Hi Renze, > I haven't used Autoport, so I can't help much with that - looking > at the output, I'm not sure this chipset is supported. > > On the console: > Have you run superiotool on your platform with the OEM BIOS? Can we > get the output from that? Is your SIO configured for IO address 0x2E > or 0x4E? > > The hang looks unrelated to the console - It looks like you're > failing in memory configuration, so I'd keep adding post codes to see > if you can track down where the actual failure is. This will > probably become plain once you get the console working though. > > Martin > > > On Fri, Mar 18, 2016 at 4:45 PM, Renze Nicolai <[email protected]> > wrote: > > Hello everyone, > > > > I am trying to port coreboot to the Asus P5G41T-M LX motherboard > > but I > > got stuck. > > > > This motherboard has: > > - Northbridge: Intel G41 > > - Southbridge: ICH7 > > - Super IO: w83627dhg > > > > I used the Gigabye GA-G41M-ES2L code as base since I think it has > > the > > same north- and southbridge. That motherboard has a different Super > > IO > > chip though. > > > > I tried to make the devicetree.cb file valid and I replaced the > > superio > > code in romstage.c with code for the superIO chip on my board. I > > also > > tried to set the correct values in the init code for the superio > > chip > > (irq routing etc). > > > > In romstage.c I added some post codes. The motherboard gets to > > postcode > > 0xA6 and then stops. > > > > Serial output is not working (cable / connection has been tested > > from > > within Linux). Terminal is connected at 115200 baud. No data is > > received. > > > > What I have so far: > > https://github.com/rnplus/test-coreboot-for-asus-p5g41t-m-lx > > > > Logs / info about the board (generated by autoport): > > https://github.com/rnplus/test-coreboot-for-asus-p5g41t-m-lx/tree/m > > aste > > r/autoport_logs > > > > > > It would be nice if someone could point me in the right direction > > as to > > what to do next. > > > > Thank you! > > > > Greetings, > > Renze Nicolai > > > > -- > > coreboot mailing list: [email protected] > > https://www.coreboot.org/mailman/listinfo/coreboot -- coreboot mailing list: [email protected] https://www.coreboot.org/mailman/listinfo/coreboot
