-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA256 On 12/10/2018 07:48 PM, taii...@gmx.com wrote: > Applicable to: > SP5100 AMD C32/G34 systems such as the KCMA-D8 and KGPE-D16. > > Situation: If you don't have OpenBMC installed you need to run > pwmconfig/fancontrol to manage fan speeds. > > Problem: > Normally the hwmon paths will change almost every boot resulting in the > need to run pwmconfig repeatedly or fix them manually in /etc/fancontrol > - this was driving me nuts so I searched for and found a solution. > > Solution: > Create a .conf file in /etc/modprobe.d/ to set sensor module load order > with these contents then reboot and fix the hwmon paths in your > /etc/fancontrol, reboot again and all should be well :D > > softdep fam15h_power pre: k10temp > softdep k10temp pre: jc42 > softdep jc42 pre: w83795g > softdep w83795g pre: radeon >
We should probably create a board documentation tips/tricks section in GIT since the Wiki is no longer available. Side note: I still wish there was an easier way to do this; I never bothered transferring documentation to GIT because of the added time / complexity vs. the Wiki WYSIWYG editor. - -- Timothy Pearson Raptor Engineering +1 (415) 727-8645 (direct line) +1 (512) 690-0200 (switchboard) https://www.raptorengineering.com -----BEGIN PGP SIGNATURE----- Version: GnuPG v1 iQEcBAEBCAAGBQJcEDuAAAoJEK+E3vEXDOFbiFEH/jYYnja1p+ujqstkZezWbuPh J6JUv3bgGFZwnexzE5MxDRbbUYfOBHDMSlBMu38pd66CHylQW5O4oQrgoWAEWDyT UC2aboSfxwKm8A6NNYvtBlwYqKoyHDl886JudCBOlhnS9xayIQvE0tI8OIVq3ao1 WHfTfDflslZxIFJjogJ440gTdPhezZrSbbWmqVjpcWe2hj/KkAPdKgMY4R0WrqsV L671iG+YB1b70+jt4fiESMgnr86XaFXvzpdXJY/COoj9bLuSRwgdCrwVEbkLc6Wd ox4Y1NwT+k9UHXuAPHdiscwIJB1EPBJoBgOeawvK5x7kr/7hbxDctmiaJyffKgs= =gGBK -----END PGP SIGNATURE----- -- coreboot mailing list: coreboot@coreboot.org https://mail.coreboot.org/mailman/listinfo/coreboot