Hi, I still have not been able to determine if there is a measurement for= the wiggle at the end of the rods. A couple folks noted a measurement from t= he manual for end-play, but I am not sure if this is the number I am looking= for or if it is the play between the rod bearing and the crank. The numbers brought up were extremely small. Perhaps there is no measurement for the amount it can be wiggled at the end and it requires disassembly and measurement of the bearings and journal to determine if all is well? The= out of round allowed is very small so I figure I might be over the limit. Th= anks for advice on the cylinders and pistons as it was most helpful. Paul, a = hair dryer did the trick on the piston pins, came right out! Glen =
____________________________________________________________________ Get free email and a permanent address at http://www.netaddress.com/?N=3D= 1 --------------------------------- to unsubscribe send mailto:[EMAIL PROTECTED] _______________________________________________________ Follow the U.S. presidential race on our Politics list! http://www.topica.com/lists/politics
<<attachment: winmail.dat>>
