----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Jon Page wrote: > > William. > Remove the main gear fairing. You will see a hole through the > gear > at the pivot joint. Put a bar or rod through this and use a hydraulic > floor jack on one end of the rod. You can lift it up until the wheel > hangs all the way down. Block the other wheels and be careful under > the > plane. An extra block,[saw horse or what ever] can be placed under the > main spar just in case the jack slipped. A rod of about 5/8" is what I > use for lifting. > > Jon Page. > FLAK MAGNET. > Make sure the fuel tanks are not too full. Because fuel will flow > 'downhill' and out the vent. Craig 2623H ==^================================================================ EASY UNSUBSCRIBE click here: http://topica.com/u/?aVxiLm.aVzvvT Or send an email To: [EMAIL PROTECTED] This email was sent to: [EMAIL PROTECTED] T O P I C A -- Register now to manage your mail! http://www.topica.com/partner/tag02/register ==^================================================================
<<attachment: winmail.dat>>
