----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- Ken; I made an angle bracket to hang two head sets on. I put it on the control column, just under the area where the side braces attach. I meant to put a note to Coupers about it, but I keep forgetting. I took a piece of .050 3/4 X3/4 aluminum angle about 10 inches long, and cut through one side of the angle about 4 inches from the end. Then I bent it 90 degrees, and put a pop rivet through the area where I had cut that overlapped each other, which formed a fairly stiff bracket. I used a 1/8 inch drill bit and drilled several holes, close enough together so that they overlapped, near the 90 degree bend but close to the back side. I used a jewelers file to turn the holes into a slot big enough so that a stainless hose clamp will go through it. Then I clamped it to the control column. This bracket holds two Lightspeed headsets with no problem. The bracket is
far enough forward and high enough so you cannot hit your knee with it even with the column full back. I run the wiring for the headsets to the middle of the panel, and after each person gets seated, I just reach under the panel and pull out the two head sets. I would make a drawing, but I am not smart enough to do it on this silly computer. However, if you are interested, I will pencil one out and send it to you. One caveat, the bracket has not been officially FAA approved, nor is there a 337! <grin> Lynn Nelsen N99387 52FL __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A The Email You Want. http://www.topica.com/t/16 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
