You are trying to do one of two things:
1) Display remote X apps that are launched from a console (ssh or telnet) on the remote machine. This is documented here:
http://xfree86.cygwin.com/docs/ug/using-remote-apps.html
2) Get a GUI session on the remote machine, just as if you were sitting on the console. This is documented here:
http://xfree86.cygwin.com/docs/ug/using-remote-session.html
Hope that helps,
Harold
Botl J. Rokit wrote:
Everyone, I hate to ask you this, but I'm just too green. Before we get into the rightful rattletrap about GUI crutches, my end users are all Win-dependent, and anything that I can remotely kick off and force their hand at is more beautiful than you'd ever know.
I have installed Cygwin on a Windows 98 and 2000 computer (twice over, two different boxes), and have been able to command-prompt over to my new Mandrake Linux 9.1 computers. I can even get to root, of course! I simply can't get the GUI to come up, when I attempt to run things like MCC (Mandrake Control Center). I get this message:
Unknown terminal: cygwin Check the TERM environment variable. Also make sure that the terminal is defined in the terminfo database. Alternatively, set the TERMCAP environment variable to the desired termcap entry. tset: unknown terminal type cygwin Terminal type?
Now at this point, I get to enter either "cygwin" (which ends up saying, again, "Unknown terminal: cygwin") or "vt100" (just to shut it up). At that point, I get a remark that says
Erase is backspace.
And that's that. Being incredibly new, I'm not even certain *where* to look. I can say, however, that I *suspect* that it's because I haven't defined something on either of my linux b0x3n. And that I'm a total newbie.
Thanks for the help. Seriously.
Eric Geater Botl J. Rokit
