On Tue, Apr 5, 2022, 8:15 AM Undiscussed Horrific Abuse, One Victim of Many <[email protected]> wrote:
> I'm still trying to figure out this oscilloscope (dso nano) which I think > needs a firmware update. > > I'm looking at a log of CLK from the voltage divider connected to my > raspberry pi. The > this is an arduino, not a raspberry pi > chart goes off the display and it says the peak-to-peak voltage is 33.6V > . It goes off > I think it might also be more than that. the display is configured for 10v increments and there are 8 vertical increments. i'm thinking it's likely calculation corruption in the device. > the display in both the positive and negative directions. > > A raspberry pi usually produces no more than > this is an arduino, not a raspberry pi > 5V, so this is some electrical thing. I don't know a lot about > electronics, but they're full of noise and stuff. > and see where failure starts >>> >>
