It works perfectly, thanks ! 2016-08-30 14:58 GMT-03:00 <[email protected]>:
> Do you perhaps have the history stack module set to "overwrite" instead of > "append"? This happens to me if I don't remember to change it back > immediately after the rare occasions that I use "overwrite" mode... > > > On Tue, Aug 30, 2016, at 10:40, François Guinot wrote: > > Hi everybody, > > > > I have 2 raw images. I modify the exposure value of the second one > directly > > through the xmp file, then i load my 2 images in DT. The exposure value > of > > the second one appeared to be correctly modified in DT. > > > > Then i make some development on my first picture, then i copy these > > developments, and past them, except the exposure value, on my second > > picture. The developments are correctly pasted BUT, the exposition module > > is automatically set off and the exposure value reset to zero ... > > > > I did not find any solution to keep the modified exposure value active > when > > i past the developments made in an other picture ... > > > > Any solutions ? > > > > > > Thanks a lot, > > > > ____________________________________________________________ > ________________ > > darktable user mailing list > > to unsubscribe send a mail to darktable-user+unsubscribe@ > lists.darktable.org > ____________________________________________________________ > ________________ > darktable user mailing list > to unsubscribe send a mail to darktable-user+unsubscribe@ > lists.darktable.org > > ____________________________________________________________________________ darktable user mailing list to unsubscribe send a mail to [email protected]
