Hi everybody, I discovered that there are three "image" sizes in darktable (sizes with Canon 40D's cr2): (a) 3944x2622 which is showed in the information panel => it is in fact the sensor size (and maybe at some point an image size, but I never saw it in darktable) ; (b) 3908x2602 is dt image size (when using the crop module or exporting to jpg) ; (c) 3888x2592 is the jpg camera size = manufacturer cropped image size.
Two points bothers me: 1. darktable image size is not the image I saw when I took the photo. I understand that information is "lost" between (a/b) and (c), but (c) is what I framed. So this additional information is, for me, unwanted in my final image. 2. with my 40D cr2, I have a 2-pixel-width red+green line on the bottom left corner on the image... so this additional "information" is even more unwanted. Last, even if it is not really annoying, I do not understand why is (a) showed in information panel, since the image size is then (b). I found that there were already some discussions about this subject here: http://sourceforge.net/p/darktable/mailman/message/27637129/ (the motivation was more about the aspect ratio, but still). Was the idea of a "vendor cropping plugin" further investigated? rejected? would it be complicated to implement? Thank you, Émile Informations from Exiftool for Canon 40D cr2: Cropped Image Width : 3888 Cropped Image Height : 2592 Sensor Width : 3944 Sensor Height : 2622 Sensor Left Border : 40 Sensor Top Border : 23 Sensor Right Border : 3927 Sensor Bottom Border : 2614 Image Size : 3888x2592
------------------------------------------------------------------------------
_______________________________________________ Darktable-users mailing list Darktable-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/darktable-users
