RE: problem of upgrading to DVEVM 1.10

Anderberg, Niclas Wed, 20 Sep 2006 00:53:49 -0700

It is not the loadmodules.sh that's the problem.

You need to upgrade your Linux kernel as there is a version mismatch between the cmemk.ko module and your Linux kernel. Use the uImage provided in DVEVM 1.1 and the problem should go away.

Regards,

Niclas

From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of jp_liu
Sent: Wednesday, September 20, 2006 6:55 AM
To: Alan Li; davinci-linux-open-source
Subject: Re: problem of upgrading to DVEVM 1.10

Alan Li, Hello

I meet the same problem when I upgrade to 1.0.32, that it is your loadmodules.sh is not correct. maybe you can try file in attachment.

jp_liu, [EMAIL PROTECTED]

2006-09-20

----- Receiving the following content -----

From: Alan Li

Receiver: davinci-linux-open-source

Time: 2006-09-20, 12:28:58

Subject: problem of upgrading to DVEVM 1.10

Hi,

I am trying to upgrade my DVEVM to the just released
1.10. By following all the instructions, i finally got
to stage where I can build the demo codes to run, but
the error occurred when I load the module and
therefore the demo codes (encode, decode, or
encodedecode) are not running at all. thanks,

alan,

./loadmodules.sh

cmemk: disagrees about version of symbol struct_module

insmod: error inserting 'cmemk.ko': -1 Invalid module
format

_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

RE: problem of upgrading to DVEVM 1.10

Reply via email to