"0200", "xx00".. but It's not the value where UBL should be started from
(0x20).. Anybody would advice the actual use of this UBL-4byte ARM start
address field?
Did you write your own UBL?
Or which UBL are you using?
I'm using the same UBL for nand flash.. got the binary, converted it to text
hex.. and send it over UART, it seems no error on sending it (the CRC-32 has
been zeroed..), but still get back to BOOTME state again..
Regards,
Ari
_________________________________________________________________
Get MSN Hotmail alerts on your mobile.
http://mobile.msn.com/ac.aspx?cid=uuhp_hotmail
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
