I don't see how that can be. The jumper makes the devices mutually exclusive so how you can you get a chip select on both of them at the same time?
--- "Allred, Daniel" <[EMAIL PROTECTED]> wrote: > This is correct. Both flash devices map to the CS2 address > space > (0x02000000 -> 0x04000000). J4 determines what device > actually gets > used (i.e. is enabled) > > > > Daniel J. Allred > > Software Applications > > Catalog DSP / End Emerging Equipment > > ________________________________ > > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] > On > Behalf Of Rudy Reinsch > Sent: Monday, October 02, 2006 7:31 AM > To: [email protected] > Subject: NAND and NOR > > > > Hello > > > > When I was experimenting with NAND programming I managed to > corrupt > > the NOR. I think both NAND and NOR use addresses 0x02000000... > > and if J4 was not set correctly for the mode you were using, > corruption > may occur. > > > > Regards > > Rudy > > > > > > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
