My LCD output via DC5 all looked OK and as I was re-checking my
cable wiring I became a bit puzzled about signals R2 and B2. These
are required for my 18 bit LCD module. According to TI's datasheet
they are Muxd with PWM1 and PWM2 - but these signals are only
brought out to the Video Input connecter DC4. Is it Me?
I also saw these signals on DC4. I let them unconnected and I see
sometimes a few pixels a little darker than they should be...
Yupe, me also left R2 and B2 unconnected in my RGB mode lcd. My plan
next time to use YPbPr 16 bit mode to have fuller colour.
Regards,
Ari
_________________________________________________________________
Find singles online in your area with MSN Dating and Match.com!
http://match.sg.msn.com/match/mt.cfm?pg=channel&tcid=281203
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
