Thanks guys for all your help so far! I have been playing with UBL over the weekend, attempting to use it to load the standard Spectrum Digital nor_flash binary onto my DaVinci (Not even thought of playing with NAND yet!)
During the terminal sequence after the RBL Menu I type: l80700000000173A8 and immediately (Using GTKTERM) click send raw file (and send u-boot-567-nor.bin) After this point the UBL just hangs. I notice after typing l that any further keypresses are not echoed back, but from the assembler code this seems correct. I have spent a little time desciphering the asm code, but still pretty unsure of what is being expected. Can someone please put me out of my misery! There will be a beer in it for ya! Regards, Andrew P.S. Rudy, cheers for sending me the code via email, I have only just today found a better version of this list online and found the code you posted a while ago on there! On Thu, 2006-10-05 at 16:43 +0200, Carlos Ojea wrote: > > I have written the equivalent in Linux and it appears to download > > correctly, I get the 'DONE' Suggesting DaVinci has used downloaded the > > the UBL but then it just starts again with the 'BOOTME'. > > What are you sending as your header? > I send " ACK 000000000BB801000000" > > Are you sending your ubl.bin in ASCII HEX word by word, LOW byte first? > > Also the first 0x20 bytes (8 words) of the binary should NOT be sent. > > Regards, > Carlos _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
