Finally I archieved to configure SPI registers. It was neccesary to 'power up' SPI module with this sequence: 1.- Wait until PTSTAT is 0 2.- Set enable state in MDCTL22 (SPI) 3.- Set 'GO' bit in PTCMD 4.- Wait until PTSTAT is 0
Now I think my registers are properly configured, but I still can't see SPI CLK in DC3 pin 5. All I should do for SPI to transmit is to write to SPIDAT1... right? Thanks, Carlos _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
