I will be connecting the USB port on the Davinci board to the serial port on the PC. It is not the question of being easy but if I can do this I can eliminate serial port on the board and use the available USB port.
Regards, Meher On 12/13/06, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote:
If you will be using a usb to serial cable, would it be easier just to use the serial port that's already there? -----Original Message----- From: [EMAIL PROTECTED] To: [email protected] Sent: Wed, 13 Dec 2006 6:56 PM Subject: Support for USB console in the early initialization Hi, Is there any support for the initialization of USB ports on davinci EVM in U-boot? I am planning to connect a usb to serial cable to the EVM and try and see if I can get early boot messages through USB instead of the serial port. Any pointers on this topic will be helpful. -- Regards, Meher _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source ________________________________ Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection. _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
-- Regards, Meher _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
