HI Carlos, I tried that I configured S3 for UART boot mode ( I tried both S3-1 and S3-2 in OFF mode and also in ON mode) but I am not able to see any messages on the UART console. I am not sure what can go wrong so suddenly but looks like UART has gone bad :(
Regards, Meher On 12/29/06, Carlos Ojea <[EMAIL PROTECTED]> wrote:
> Any ideas from on how to debug this and to confirm UART on board is > good/bad are appreciated. To see if UART on board is bad, you could configure S3 to boot from UART. When you power on your DVEVM you must see the messages BOOTME BOOTME .... Regards, Carlos
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
