Hello, Recently I use ZyXEL G-220v2 USB WiFi Adapter with ZD1211LnxDrv_2_15_0_0.tar.gz driver on 2.6.10_mvl402. I could successfully download Firmware to usb adapter and register network interface 'eth1' to system. Then, I use 'ifconfig eth1 up' to activate interface. But, the interface hadn't any response after activate step. So, I still couldn't use wireless functionality on the davinci board.
Any suggestion, appreciated! > >Hi All, > >Recently some people asked about running WiFi and about problems with ep0. >Today I managed to run (not yet finally) zd1211/ar2524 + UW2453 RF >with ZD1211LnxDrv_2_15_0_0.tar.gz driver on 2.6.10_mvl402. > >The problem was that FW was not actually loaded over ep0 without any >error notification (because of musb_hdrc). It was possible to see only >with USB Analyzer. > >The solution is to introduce small delay between USB handshake and FW loading. > >BTW: there is zd1211rw in 2.6.18+. > >-- >Constantine Shulyupin >Embedded Linux Consultant >Israel Tel-Aviv >054-4234440 >http://linuxdriver.co.il/ >
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
