Hi all, I have made changes ( serial.c, board-evm.c, clock.c, vr41xx/common/serial.c) as per suggested by Inder and SangJae H and kept the uImage in tftpboot after changing mode to a+r. I had already configure the board such that it always boots form /tftpboot/uImage of NFS.But now board doesn't boot on the new uImage. Am I missing something?
Nainawat Skema -France On 2/22/07, Amit Nainawat <[EMAIL PROTECTED]> wrote:
Hi follows, Dose any one knows which document I should refer to add UART 1? I am working on the example (demo) code supplied with dvsdk, I checked on digital spectrum site which says that UART1 and 2 is not functioning. And how is addressing is done for uart ports? Thanks Nainawat Skema France > On 1/17/07, Hartenberger, Joerg < [EMAIL PROTECTED]> wrote: > > > Hello! > > > > > > > > Did you test UART1 Communication on the board ? I cannot measure any > > UART RxD TxD Signal on DC2 Connector. Even not in the 1V8 power domain > > > > Are you sure it should work in this way. > > > > > > > > Did you test UART 1 communication ? > > > > > > > > Thank you > > > > > > > > *DI Joerg Peter Hartenberger* > > > > Embedded HW/SW Developement > > > > Zydacron / Scotty Group > > > > Teslastrasse 4, A-8074 Graz, AUSTRIA > > > > Tel.: +43 316 409 426 622 > > > > Fax +43 316 409 426 529 > > > > [EMAIL PROTECTED] > > > > www.zydacron.com > > > > > > > > > > > > _______________________________________________ > > Davinci-linux-open-source mailing list > > [email protected] > > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > > > > > > >
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
