Hi Steve,

I reproduced your soft reset problem on our boards and on evm.

In the mean time TI provided us UBL source code, so I did some patching. I implemented workarounds for both soft reset and STM NAND flash. Code works OK at least for me. I submitted patches to Roger.

Ivan

Steve Yeh wrote:
Hi Roger,

This situation is happened on standard evm and it works fine when using NOR boot.
We use the kernel from dvevm 1.10 but elder u-boot.

Currently, we manufacture our own board and use STM flash.
So we face the same problem as Ivan faced. The flashwriter from TI can not work on our flash.
Our hardware engineer is working on this issue now.

Steve



2007/3/2, Monk, Roger < [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>>:

    Steve – some more questions to help us track this down :-

    Is this on standard evm or custom hardware?

    Which version of Uboot are you using? – Is it the latest from the
    ti extranet?

    Which version of linux kernel? – the one that comes with dvevm v1.10?

    Does reboot work successfully from NOR or is it also failing from NOR?

    Does reboot work successfully when using the MV filesystem, rather
    than your ramdisk?

    ~roger

    ------------------------------------------------------------------------

    *From:* [EMAIL PROTECTED]
    <mailto:[EMAIL PROTECTED]>
    [mailto:[EMAIL PROTECTED]
    <mailto:[EMAIL PROTECTED]>]
    *On Behalf Of *Steve Yeh
    *Sent:* 02 March 2007 10:41
    *To:* [email protected]
    <mailto:[email protected]>
    *Subject:* reboot fail when using nandflash

    Hi,

    Does anybody face the following problem? Any comment?

    Thanks a lot.

    Steve


      I storage kernel and ramdisk on nandflash and boot evm form it,
    but I can't reboot my system by submit "shutdown –f –r now" or
    "halt -f" both and system will show "system is reboot now" or
    "Booting PSP Boot Loader" and then no any response. As I know,
    "Booting PSP Boot Loader" was printed by boot loader, but I don't
    know why it's not go on. Any commands?

    P.S "halt" and "shutdown" were copy form evm hard disk (under
    /sbin) not soft link to busybox, any I copy all /etc form evm hard
    disk to my ramdisk.


------------------------------------------------------------------------

_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
begin:vcard
fn:Ivan Tonchev
n:Tonchev;Ivan
org:Multimedia Solutions (MMS);IT
adr:;;Tintiava 15;Sofia;Sofia;1113;Bulgaria
email;internet:[EMAIL PROTECTED]
title:Network Administrator
tel;work:+359 2 868 9186
tel;cell:+359 88 608 9664
url:http://www.mm-sol.com
version:2.1
end:vcard

_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source

Reply via email to