Hi, I will bringing up our custom board in the next day to two when it's ready. Since everyone says the easiest test to do is put the board in "UART boot" mode and see if the CPU is cycling and UART is working. Our custom board is using a 24Mhz crystal oscillator instead of 27Mhz. Since we're using 24Mhz instead of 27Mhz, how does the Davinci know what divider value, etc to use to divide that clock down to 115.2 kbps to get the serial message "BOOTME" out correctly? Do I have to do anything special? Thanks.
Regards, Andy
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
