I appear to have solved this by using the bootarg [EMAIL PROTECTED],0 where 800x600 is the resolution and 0,0 is the position. However now my app won't run because it's detecting PAL video standard but I'm using an NTSC camera, probably something going wrong in detectVideoStandard() as it was probably only meant to detect between PAL and NTSC displays rather than higher res displays. Euan
-----Original Message----- From: Cochrane, Euan [mailto:[EMAIL PROTECTED] Sent: 23 November 2007 10:44 To: Davinci-Linux-Open-Source (E-mail) Subject: davincifb davincifb.0: davincifb_check_var :within_vid0_limits fa il. Hi, so I have now managed to get a digital output on DC5 but when I boot the board to use DC5 I get this error appearing during the boot sequence and when I try and run my app or any of the demos. My display setup is based on the 480p prgb config (included in the 1.20 drivers) that also causes the same problem. I can see the output on DC5 (with a scope I don't have anything attached yet) including syncs and data on the cout and yout pins but when I try and run my app it fails. Anyone know how to fix this? Thanks, Euan _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
